Actually, I took two of these down just a few weeks ago- it sounds like it's at
least partially correct to me... Rohn 25 requires two bolts for each leg, and
they differ in diameter and tool-flat size. If the field-day tower is 3
sections and a top section, it should require 12 bolts of about 3/8" diameter,
and 12 bolts of about 7/16" diameter. Note that Rohn bolts are fine-thread, and
when inserted, the bolt's unthreaded 'neck' will extend right up to the outside
edge of the leg, so that when you torque it, the nut will slightly compress the
leg, and bottom against the bolt's neck. The neck will also completely fill the
tower leg hole, not just 'drop in', as this allows the inner and outer leg to
'shear' the bolt and maul the tower-leg holes. It'll also generate enough yukky
noise in your Ten-Tec that you'll want to use the 'real' bolt...
DK :-)
Quoting "Dr. Gerald N. Johnson, electrical engineer" <geraldj@isunet.net>:
> Some one has drilled out some of the holes for larger bolts they had on
> hand...
>
> 73, Jerry, K0CQ
> Stuart Rohre wrote:
> >
> > I believe when you get to the top section, there are differing bolt
> sizes.
> >
> > Our club has about 40 feet of Rohn 25 and it takes two differing sizes of
> > nuts and bolts to assemble for Field Days.
> > -Stuart
> > K5KVH
> >
> --
> Entire content copyright Dr. Gerald N. Johnson, electrical engineer.
> Reproduction by permission only.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|