TenTec
[Top] [All Lists]

Re: [TenTec] Using a comptuer microphone with a Triton 4 (544)

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Using a comptuer microphone with a Triton 4 (544)
From: "Paul Gates, KD3JF" <pearly732003@yahoo.com>
Reply-to: kd3jf@arrl.net,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 16 Nov 2007 14:22:16 -0800 (PST)
List-post: <mailto:tentec@contesting.com>
I have a 544 and the 580 and I get the best reports with my D-104. I think the 
talk that it was not a SSB mike may have come from Astatic themselves when they 
came out with the 10-D mike which was promoted as a SSB mike. It was a good 
mike and I used it for years with my Drake TR-4. 

when I recently traded for a 580 Delta I thought I would try the 10D on it. 
Guys told me "Go back to the D-104 the audio is better. I have 2-D104's. My 
daughter N3GIG has a D-104 with her Atlas 210X. My granddaughter has a D104 
with her TR-3.
Paul, KD3JF

N4NT <mike_n4nt@embarqmail.com> wrote: This is absolutely untrue in my 
experience.  I have compared microphones on 
the Triton 544 and ALWAYS the listeners prefer the D-104.  Folks who know me 
in person say the D-104 has the best representation of my voice.  Based on 
my experience, the D-104 is FAR from being a crappy microphone!

73, Mike N4NT

----- Original Message ----- 
From: "Dr. Gerald N. Johnson" 
To: 
Sent: Friday, November 16, 2007 11:36 AM
Subject: Re: [TenTec] Using a comptuer microphone with a Triton 4 (544)
>
> The D-104 is a crappy microphone for SSB, always has been. It has a
> rising characteristic intended (in the 30s) to emphasize the highs at
> the transmitter that were rolled off in the typical AM receiver IF
> selectivity that had a very rounded pass band. Further the crystal and
> ceramic D-104 were designed to work with a very high impedance load for
> solid state, preferred load a megohm. Today a high impedance solid state
> audio input impedances is likely to be under 100K. That load on a D-104
> changes it from rising to peaked and falling, makes it sound muffled. It
> it still had the rising characteristic with the solid state input Z, it
> can overdrive audio and balanced modulator with audio components
> rejected by the SSB filter unless in super wide SSB mode which draws a
> lot of fire on the bands.
>
> Yes, I have a D-104 (case) hooked to my Corsair II. The cartridge is a
> Shure limited bandwidth communications element no longer made.
>
> 73, Jerry, K0CQ 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


       
---------------------------------
Never miss a thing.   Make Yahoo your homepage.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>