Bill-
I think the Omni C still had a high impedance mic input.... which means your
dynamic Midland mic probably won't have enough output to drive the mic
amplifier. One could wire it up, and try it out, though. I always open the mic
case and figure out how the mic is wired internally, and that will determine
what wire goes to which: TRS on the phone plug. If you don't have the ability
to do that, maybe ask around at a local club meeting, and ask if someone is
willing to teach you. It's a great skill to have, to be able to wire up
different mics to your rig. If I were closer, I would gladly work through it
with you over a couple cups of coffee ;-). Enjoy your Omni C, and let us hear
it on some of the many TenTec user nets on the air. just look up K3UR on
QRZ.... you will find a list of net times/frequencies. ALL are welcome!
Kind regards,
Greg in West Mitten, KC8HXO
--------------------------------------------
On Fri, 2/16/18, weaver615 <weaver615@gmail.com> wrote:
Subject: [TenTec] Mic Wiring
To: "tentec@contesting.com" <tentec@contesting.com>
Date: Friday, February 16, 2018, 12:27 PM
Hello everyone. I have a Ten-Tec Omni C. I
currently have a D-104 wired for it that I am using. My
question(s) are, can the Midland 500ohm Hand mic be wired
for this radio and if so does anyone have the wiring diagram
for it...I have researched it online but cant seem to find
anything out about these questions and I would like to have
a back up mic whenever possible...Any help would be greatly
appreciated. Thanks.
Bill - K2WPL
A pic of the mic in question is
attached.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|