| To: | TenTec@contesting.com |
|---|---|
| Subject: | [TenTec] RX366 Manual: no mention of IF ouput |
| From: | amsctalx@comcast.net |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sat, 11 Feb 2012 14:08:59 +0000 (UTC) |
| List-post: | <tentec@contesting.com">mailto:tentec@contesting.com> |
I was perusing the RX366 Installation and Operation Manual (74467 Rx366 V1.4 1-18-12 Instructions.pdf) on the Ten-Tec website, and couldn't find mention of the IF output. Was I simply unable to find mention of the IF output, or was it overlooked by the author? Is the connector that is cryptically labeled "Your text here" the IF output? What is the recommendation for bringing the IF outside the enclosure? Thanks, Mike Alexander - N8MSA amsctalx@comcast.net _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Omni 6 Opt.3 Problem, Gary Winkelman |
|---|---|
| Next by Date: | Re: [TenTec] Tentec Omni D no (low) power output, Mike Bryce |
| Previous by Thread: | [TenTec] FW V3.026: Minor bug report - Sweep display freezing, Peter Frenning [OZ1PIF] |
| Next by Thread: | [TenTec] RX366 Manual: no mention of IF ouput, John Henry |
| Indexes: | [Date] [Thread] [Top] [All Lists] |