On Sat, 2009-05-16 at 23:00 -0700, Clark Savage Turner wrote:
> Hi
> all - I've played hookie for over a year now, but I'm back :-)
> Picked up a Corsair II from an estate, low receive.
> The receive is down to about the level of the isolation of the RX
> antenna - if I have the antenna plugged in to the TRX jack, the PL
> 259, it is about the same level as when it is plugged in to the RX
> jack with the slide switch to the TRX side. Anyone recall what diode
> was at fault? The rest of the rig seems to work about right, and its
> filled with filters. There are lots of awful hacks here and there,
> I've done some rewiring and cleaning, but I'm happy so far with the
> results. Now, if I could just get the receiver up to specs when I
> connect to the PL 259 with the slide switch to TRX. Well, then I'll
> need to rebuild the PTO, but I can do that in my sleep now :-)
> Anyone with hints, I appreciate it.
> Oh, and I have one set of spare side panels (wood grain) for the
> Argo 505 and 509 (I think) if anyone needs them.
> Clark
> WA3JPG
> Clark Savage Turner, J.D., Ph.D.
> Professor of Computer Science (and regular guy)
> Cal Poly State University
> San Luis Obispo, CA. 93407
> _______________________________________________
D1 and D2 on the LPF-TR board 80869. My book doesn't have the parts
list, does any? Also check Q2, a 2N6514. a transistor used to shunt the
receive signal, driven by +T.
73, Jerry, K0CQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|