Like I was saying, it's almost exactly the same part number. The stock part is
Bourns ENA1J-B28-L00128 and the one on Ebay is ENS1J-B28-R00128. If you check
the Bourns EN series data sheet, you'll find that the only differences are that
the Ebay one has a ball-bearing shaft and it has radially oriented connector
pins instead of axially oriented (both, I think are better for this
application). It's the same 128 ppr, 1/4" shaft encoder and it is working great
in my rig.
It was too good of a deal to not pass the info along.
Curt, K8AI
________________________________
From: "Jerry, N9AW" <n9aw@sbcglobal.net>
To: Curt Benjamin <k8aicurt@yahoo.com>; Discussion of Ten-Tec Equipment
<tentec@contesting.com>
Sent: Thursday, September 27, 2012 11:50 PM
Subject: Re: [TenTec] OMNI VI replacement encoder
Fantastic fix Curt. How did it fit mechanically to the front panel and the
circuit board.
73
Jerry N9AW
----- Original Message ----- From: "Curt Benjamin" <k8aicurt@yahoo.com>
To: <tentec@contesting.com>
Sent: Thursday, September 27, 2012 6:15 PM
Subject: [TenTec] OMNI VI replacement encoder
> I thought I'd pass this along: My Omni VI wouldn't change frequency so I
> subbed the RIT encoder and confirmed a bad encoder. I found one on Ebay that
> not only was close but better than stock (it's got a ball-bearing shaft
> instead of the stock one with a bushing only). Not only is it working better,
> it's only $21 shipped! Needless to say but I bought another one today to have
> on hand. Here it is:
>
>
>
> http://www.ebay.com/itm/BOURNS-ENS1J-B28-R00128-OPTICAL-ENCODER-/370592502534?_t\
> rksid=p5197.m1992&_trkparms=aid%3D111000%26algo%3DREC.CURRENT%26ao%3D1%26asc%3D1\
> 4%26meid%3D2306168450466681064%26pid%3D100015%26prg%3D1006%26rk%3D1%26sd%3D37059\
> 2502534%26
>
>
> Curt, K8AI
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|