I bought a cheap Chinese frequency counter bar from eBay. I wired the counter
input to the output terminal from the PTO box on my 509. It can be reached by
sliding open the bottom cover on the radio cabinet.
I knew the MHz readout would read wrong since it’s the injection frequency,
but I could use four lowest digits (for example, 330.5), plus the known MHz
from bandswitch, to determine my exact frequency, to hundred hertz.
However, the readout was 300 hertz lower than the actual frequency. I couldn’t
find an adjustment on the counter to zero it, so later disconnected it. It was
only a temporary test setup. My plan was to mount the counter in a box, and use
cables with RCA phono plugs to get 12V operating power for counter, and rewire
the 509 AUX phono jack to bring out the VFO signal.
I haven’t done anymore work on it, but may get back to it sometime.
-de K4CWQ.
Sent from my iPhone
> On Apr 2, 2021, at 2:41 PM, ROLAND HOWELL via TenTec <tentec@contesting.com>
> wrote:
>
>
> Good Evening Gents
>
> Question for you, is it possible to fit a frequency counter to the above
> radio, It would nice to know what the actual 'F' is in relation to the scale.
> If anybody has done this mod, please advise and if possible supply connection
> details, although the radio is sold i would like to supply the new owner with
> as much info as possible.
> 73
> Snowy G0HZE
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|