>From: "Bob Stephens" <bstephens1@mindspring.com>
>To: <tentec@contesting.com>
>Sent: Saturday, August 06, 2005 10:27 PM
>Subject: [TenTec] Corsair problem
> My Corsair display reads 9.1 followed by zeros
> on 160-20meters and 9 followed by zeros 0n 17 >
through 10. It does not receive and turning
> the dial does not affect the frequency.
>
> Any ideas?
>
> Bob,
> KB1CIW
Bob, In addition to the suggestions of others, check
to make sure that the jumper plug is installed in the
multi-pin molex socket on the rear. Two pins must be
jumpered together to supply power to the PTO. This
jumper is pulled when the accessory VFO is used.
I wasted an hour troubleshooting a Corsair only to
realize that the accessory dummy plug was missing.
73,
Doug/WA1TUT
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|