The voltage difference is simply a different coil -- higher voltage, less
current. I agree the mounting method contributes to the noise. But it
doesn't bother me -- I wear headphones. :)
Note that a company called Gigavac makes and sells their own versions of
these relays to hams at a nice discount. google to find them. I've bought
several for Titans and Herc II, and installed several. None have been
installed long enough to be considered a test of reliability, but none
have failed yet either. I work 99% CW (except SSB for some contests) and
ALWAYS QSK. I'll typically do >500 Q's in a contest weekend.
73,
Jim K9YC
On Fri, 07 Dec 2007 12:11:25 -1000, Ken Brown wrote:
>I have a Titan 425 and a Hercules II 420 amplifier. The vacuum relays in
>the two amplifiers appear to be the same model. The vacuum relay in the
>425 makes much more noise. I know it uses a higher voltage to actuate it
>that the 420 does, 20 V versus 13 V. That may be part of the difference
>in noise. I am wondering if differences in the mounting of the relays
>and the stiffness of the wires connected to the relay is also an
>important factor in the amount of noise radiated (acoustically) from the
>relay. I am considering replacing the grommets that the relay board is
>mounted with, and adding short lengths or braid in the connections to
>the relay (not stiffened by being totally soaked full of solder) to help
>isolate the relay vibration from the rest of the chassis.
>Anyone out there tried any of this already? I'd be interested to hear
>about your successes and/or failures.
>DE N6KB
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|