Re: [TenTec] Ten Tec Centaur 411 10m Mod Needed

[w8au@sssnet.com]

At 08:10 AM 2/13/2014, you wrote:
> I just acquired a Ten Tec Centaur 411 amp from an SK estate.  As it turns
> out, it was never updated for 12/10m use.  Ten Tec noted they did not have
> the board to enable 10m.  Any suggestions on a possible source or circuit
> diagram would be appreciated.
Doug:

Had to do this to our club Centaur.  TT no longer has the plug in board but
will supply the pi-section filter schematic/parts values for it.  You have to
fabricate your own board, which goes in place of the 15 meter output filter.

Have fun..

Perry   w8au

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec