TenTec
[Top] [All Lists]

[TenTec] Port sharing software for Orion/LP-Pan?

To: tentec@contesting.com
Subject: [TenTec] Port sharing software for Orion/LP-Pan?
From: Ben Antanaitis - WB2RHM <wb2rhm@wb2rhm.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 10 Jul 2014 11:04:07 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Barry,

I use HRD 'Classic/Free/V5' and VSPManager to successfully interface NaP3 to my 565 and N1MM. HRD drives the 565 CAT, uses a DDE interface into NaP3, and provides a 'virtual kenwood interface' to N1MM thru the Eltima virtual ports created by the VSPManager. This work fine for me. There is extra overhead to run HRD, but the NaP3 'native Orion' support works on the 566 but not on my 565, hence I use the HRD Orion CAT support. I never could get Pete to work with me to troubleshoot what was going wrong in the 565 support in NaP3.
73,
Ben - WB2RHM

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>