TenTec
[Top] [All Lists]

Re: [TenTec] New Eagle vs. Used Omni VII

To: N4PY <n4py2@earthlink.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] New Eagle vs. Used Omni VII
From: Scott Harwood <scotthsr@earthlink.net>
Reply-to: Scott Harwood <scotthsr@earthlink.net>, Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 24 Dec 2010 09:19:16 -0500 (GMT-05:00)
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Good solution, Carl.  I don't own an Eagle nor have I read the manual, so my 
suggestion to unsolder and change key cables was just out of "ham creativity".

Scott K4VWK


-----Original Message-----
>From: N4PY <n4py2@earthlink.net>
>Sent: Dec 23, 2010 6:54 PM
>To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
>Subject: Re: [TenTec] New Eagle vs. Used Omni VII
>
>I would just use the key line on the accesory cable.  If my memory is 
>correct, this is the black female RCA jack omn the acessory cable.  This key 
>line is great for straight keys and external keyers since it does not matter 
>if the imternal keyer is turned on or not.  And this line works for both 
>keying in CW and PTT in SSB.
>
>Carl Moreschi N4PY
>121 Little Bell Dr
>Hays, NC 28635
>www.n4py.com
>
>
>----- Original Message ----- 
>From: "Richards" <jruing@ameritech.net>
>To: "Scott Harwood" <scotthsr@earthlink.net>; "Discussion of Ten-Tec 
>Equipment" <tentec@contesting.com>
>Sent: Thursday, December 23, 2010 6:43 PM
>Subject: Re: [TenTec] New Eagle vs. Used Omni VII
>
>
>> How would YOU terminate the cable at the rear of the rig?    Would you
>> drill a hole for
>> a jack or just run the cable outside the rig and terminate with an
>> "in-line" plug?   Or some other plan I have not thought of?
>>
>> ====================  K8JHR  ================================
>>
>> On 12/23/2010 5:39 PM, Scott Harwood wrote:
>>> Hey guys.  We're hams!
>>>
>>> How difficult is it to disconnect the cable from the rear plug and run 
>>> the cable from the front plug back to the rear?
>>>
>>> Then, when you sell or trade the rig put it back as it was.
>>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec 
>
>_______________________________________________
>TenTec mailing list
>TenTec@contesting.com
>http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>