Hi John....
I wanted to personally thank you for your support. I know you guys get beat up
more than you're share on this stuff. Your products are top notch.
Have a Merry Christmas and a Healthy and Prosperous New Year!
Cecil Acuff
K5DL
Sent from my iPad
On Dec 20, 2012, at 3:50 PM, John Henry <jhenry@tentec.com> wrote:
> Just posted an update on the TenTec web page for the Orion II Model 566.
>
> Version 3.033xa December 20, 2012
> Added S-Meter Calibration
> The procedure is downloaded with the 3.033xa update, There is a
> start-menu link. e.g. in
> Windows, click on Start, All-Programs, Ten-Tec, OrionII Firmware
> Update, then look for the file
> S-Meter 565 566 Calibration Procedure
> Corrected Sweep alignment in LSB
> Corrected SAF/Notch setting after power up.
>
> The procedure is not necessary, but allows those that want the S-Meter
> readout to be as exact as they can get it, they can adjust it. It is
> actually adjusting the voltage level to the meter, e.g. when the
> software detects an S-9, it will look up the value in this table and
> use it to drive the meter. It does not adjust what is read by the
> software, an S9 is still an S9 in the software.
>
>
> --
> ==============================================
> John Henry, KI4JPL Phone: 865-453-7172 x234
> Engineering Direct: 865-868-4915
> TenTec, Inc. Fax: 865-428-4483
> 1185 Dolly Parton Parkway
> Sevierville, TN 37862
> www.tentec.com E-Mail: jhenry@tentec.com
> ==============================================
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|