I think I may have a board for you.
Send photo.
Gary
> On Dec 23, 2018, at 11:28 AM, Peter Bertini <radioconnection@gmail.com> wrote:
>
> I just spend a day working on a replacement 81597 board for my Omni VI
> rigs... added the ten turn pots.
>
> Odd thing is when I tried to align the board, obtaining the 400 Hz offset
> for CW was impossible. After pulling my hair for a few hours, I traced the
> runs and discovered there were no trimmer caps for CW offset on the 9 MHz
> LSB crystal! The board is marked 81597 92842 REV A. No way it could have
> ever worked in an Omni VI, even though it supposedly came from a scrapped
> unit. It seems to follow the BFO scheme used in the earlier V models.
> Board can be modified by swapping the LSB and USB lines, and reversing the
> two crystals. Weirdness never ceases.
>
> Pete
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|