I was going to say something about doing that on the forum bit though for sure
someone would had mentioned it.
Mike wb8vge
Sent from my iPhone
> On Feb 19, 2014, at 9:29 PM, "A R" <raf_3@msn.com> wrote:
>
> Mike,
>
> Thanks! Pulled the P22 plug (schematically labeled "KEY/GND", and the
> processor keyer output is disabled, AND I still have straight key/bug CW
> capability. I can sure live with that.
>
> 73!
> Allen----W7GIF
> ----- Original Message -----
> From: Mike Bryce<mailto:prosolar@sssnet.com>
> To: Discussion of Ten-Tec Equipment<mailto:tentec@contesting.com>
> Sent: Wednesday, February 19, 2014 4:02 PM
> Subject: Re: [TenTec] Corsair II UV EPROM failure
>
>
> Iam surprised no one mentioned this before
>
> Unplug the two wire plug ( that is the output from the microprocessor near
> q3) on the 81246 logic board.
>
> Problem solved!
> Mike wb8vge
>
> Sent from my iPhone
>
>> On Feb 19, 2014, at 5:31 PM, Steve Berg
>> <wa9jml@frontier.com<mailto:wa9jml@frontier.com>> wrote:
>>
>> Allen, you do not have to use the internal keyer in the Corsair II. If you
>> do, there is a jumper with two RCA phone plugs on it that goes from the
>> keyer out connector to the key connector. I unplug that many times to hook
>> up my bug or straight key. I just plug them into the key jack once the
>> jumper is removed.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com<mailto:TenTec@contesting.com>
>
> http://lists.contesting.com/mailman/listinfo/tentec<http://lists.contesting.com/mailman/listinfo/tentec>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|