You'd better check the bias setting of that rig. If that dosnt work check the
finals. I had the same problem with a Paragon. It suddenly started the the same
thing. The problem was that Ten tec, in constructing the radio forgot to solder
the Bias pot and it was making a mechanical connection until the heat caused it
to
open up . The resultant instantaneous current draw caused the power supply to
shut down. Good luck Joe AKA kf5mc
Ritzman@aol.com wrote:
> Hello all:
> I attempted to put a newly acquired Omni D Model B on the air this weekend but
> encountered a problem and was hoping someone would recognize the symptoms I
> observed with the radio. First, the rig was very difficult to tune into a
> G5RV on 15 meters. The tuning proceedure was by the book: first find an
> inductance setting that produced maximum background noise on RX then, under
> low power, adjust the tuners transmitter and antenna reactance controls for
> minimum SWR. (1.2:1) Upon bringing up the power, the power supply breaker
> tripped. Checking the power supply, the meter indicates the Omni drawing 3
> amps at idle (receive only) and the heat sink on the rear of the rig is almost
> too hot to touch.
>
> Are these classic signs of blown finals or might something else be the
> culprit? Thanks in advance for any thoughts you can pass along.
>
> 73,
> Steve KB1CHS
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|