Hello Duff,
Got the same problem with my Jupe-have had several other rigs in the shack
and every time I spoke to anyone at Dollyland,the stock answer was "you must
have RF in ur shack".Got a darn near bulletproof ground system here
and,no,other rigs do not exhibit ths problem.Basically,T/T rigs do not have
good shielding and if you can live with this,thay are great.
The problems with my Jupe are simalar to yours:
1.On 20 mtrs,RF gets into my D104 mike-if I use a T/T 700 handheld,no
problem.
2.On 17 mtrs,RF gets into the T/T 700 but not into the D-104.
3.When using the J-303 remote pod on 10 mtrs,the xmit freq will automaticlly
start counting downward unless I "wriggle" the tuning knob on the
remote-then it stops:this only occurs while in front panel operation.
When in Peg emulation mode,the problem does not occur.
Basically,the fundamental problem is piss poor shielding in the Jupe.
73 de Bill W4NJF
Bill Fulling
w4njf@email.midflorida.com
----- Original Message -----
From: "J. Duffy Beischel" <duffyb01@fuse.net>
To: <tentec@contesting.com>
Sent: Saturday, September 21, 2002 10:56 AM
Subject: [TenTec] Jupiter Issue
I installed 1.23 of the firmware and have a new, but very strange problem.
I am using an LDG AT 11MP autotuner with the Jupiter. When on 15
meters, and this only happens on 15 meters, if I press the tune button
on the Jupiter, the rig immediately changes frequency to somewhere
between 20 and 22 Mhz. I have tried all other bands and everything
works fine on those bands. Anyone else experience this?
Duffy
www.wb8nut.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec