Doug,
I had the same problem. It turned out that the PA-board drawed to much
current (and further more the current increased rapidly), even with no
driver at all - Bias was ok and I suspect a fault in the finals.
Expecting my purchased pa-board soon...
73, Harry, DH1NBE
Am 16.05.2017 um 22:13 schrieb Doug Snowden:
I have an OMNI 6+ that instantly shuts down when keying on CW with no
output drive or on SSB with mike gain at zero. It is not an SWR
issue. Any hints? Just put it on the bench to start looking at it.
The manual describes the ALC circuit pretty well.
Doug N4IJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|