Jim Reid wrote:
> > If AGC Threshold control was reasonably accessible,
> > I bet you'd be using it all the time.
> Yes, sure enough! The Threshold may be set via a
> slider at the left side of the "virtual" Orion control
> panel when using the N4PY control software. Very
> nice that way.
You just sold me the software :-)
> AGC threshold is printed in uV just below the slider
> on Carl's panel, so you always know where it is.
Wishing it was in S units!
73,
Sinisa YT1NT, VA3TTN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|