Subject: Re: [TenTec] Omni VI confusion
Well sort of...There's lots of little things TenTec did when they came out
with the 564, VI+. For example. The option caused some birdies. They cut
cable 34 between the logic board and 9mhz IF and inserted RF chokes in
series then put heat shrink tubing over them In the VI+, they rethought the
process and installed a little circuit board with smd parts on it. Cable 34
goes into and out of that.
=======================
Interesting Steve, are there any known mods to reduce the birdies in the
opt3?
The Omni6 opt 3 alignment went fine btw, thanks.
73, Deni
F5VJC / GM3SKN
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|