TenTec
[Top] [All Lists]

Re: [TenTec] Corsair II & Omni V Filters

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Corsair II & Omni V Filters
From: "Carter, K8VT" <k8vt@ameritech.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 27 Nov 2007 08:14:16 -0500
List-post: <mailto:tentec@contesting.com>
Gary Smith wrote:

>  The rig seems to have a problem; the VFO A light does not light up

You have to use the button on the front panel labeled "A/B". This will 
toggle between the two VFOs.

>  and if I hold the "rev" in while changing freq it does nothing. The
>  only way I have seen the "rev" button have an effect is if I have VFO
>  B and split enabled. If I do so and move the VFO, when I press "rev,
>  it shows the earlier frequency.

This is the way it should work. "REV" only works if "SPLIT" is on. If 
you are actually going on the air in this mode, don't forget to press 
the "A=B" button the first time you go into split.

73,
Carter K8VT

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>