Likely you have a bad relay on the band pass filter board.
I have spares.
Gary
Sent from my iPad
> On Mar 15, 2018, at 3:27 AM, David J. Ross <rossdj@verizon.net> wrote:
>
> I haven't experienced it in my Paragon but I have read other post where that
> issue was traced to shorted PIN diodes in the LPF.
>
> -----Original Message-----
> From: TenTec <tentec-bounces@contesting.com> On Behalf Of Richard via TenTec
> Sent: Tuesday, March 13, 2018 8:23 PM
> To: tentec@contesting.com
> Cc: w2ssx@yahoo.com
> Subject: [TenTec] paragon 1
>
> Paragon rx and tx all bands except on 80 where there is no output but weak
> receve signal.when I connect the antenna to the aux. ant jack ,on back of
> radio,by passing the low pass filter board,receve signal is normal but,
> still no output .think problem in lpf board .having trouble,trouble
> shooting. any ideas appreciated. thanks rich (w2ssx@yahoo.com)
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|