The Omni VI and VI+ use regular RS-232 serial communications. If you
have a regular serial port on your computer you do not need any level
conversion. The pins used on the 25 pin D connector for TX data, RX data
and data ground on the Omni VI are probably not standard, so you may
need to build your own cable.
DE N6KB
> The OMNI VI and VI+ both did computer control using a superset of the ICOM
> command set. You can use any of the ICOM level converters to drive it, and
> in some software us the IC-735 profile to control many (most?) of the
> controllable features of the rig.
>
(excuse me, I guess todays hams don't build dipoles or install
connectors on their coax, so I guess you'll have to buy one)
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|