Hi Art -- I would check the baud rate. Should be specified
in the user manual.
I do not have a Pegasus, but that often resolves issue I see
with my Omni VII, RX-230D, and TS-590s -- all of which seem to
have similar issues when I do a re-build, and the baud rate is
often the sticking point. No guarantees, but I would check that
out as you suggest.
In any case, if that is not the issue, then you have eliminated
that as the problem.
------------------
Happy Trails.
======================= Richards / K8JHR =========================
On 6/19/2011 00:57, Art Trampler wrote:
> However, I haven’t been able to get the Pegasus recognized.
> Is there a particular Baud I should select?
>
>______________________________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|