Mike - I'm curious about just what you think isn't right about the
spectrum display frequency. I have 3.029 installed on my O2 and the
display looks just as it should - LSB signals to the left of center, USB
to the right, CW just about centered. I guess I'm amazed that anyone
would even use the O2 spectrum display, let alone try and make any
frequency determinations from it. While I love my O2, I must say that
the spectrum display is on the other side of dreadful. I might glance
at it to see if there are any signals on the band at all, but even then
I wouldn't make a decision based on what I saw. Looking at the same
apparently dead band using the IF output and an SDR-IQ usually reveals
many weak signals. I'd like to see Tentec not spend another millisecond
on anything to do with this spectrum display implementation. The
resolution just isn't there and the delay between hearing and seeing a
signal on the display makes it just about useless.
73, Floyd - K8AC
On 4/28/2012 3:02 PM, Mike Stricker wrote:
Hi,
I was wondering if I am the only one who thinks there is at least one
unresolved issue in this latest version of firmware. I'm not talking about
things that you'd like to see, but things that just aren't quite right yet.
For me, the fact that the spectrum display peak does not line up with the
actual frequency on LSB and CW modes is rather annoying. I was hoping that if
this is the only unresolved issue for V3.029, a quick update can be made and
Ten Tec can begin to work on new features.
Mike, WA1SEO
|