I'm dumb!
The Orion was operating perfectly until, it had a complete input power
failure. It turned off instantly. I found the 25 Amp fuse holder which
is rated at 15 Amps had failed. The holder burned in to a melted plastic
mess.
I took the back panel off, and removed the PC board. While removing the
board I took a picture of the wire connections that were solder
attached. I unplugged all of the numbered cable connections. Since Ten
Tec always stencil the cable numbers next to the jack I didn't take a
pic of the numbers and locations.
I went to Ten Tec and picked up a under-rated fuse holder and installed
it. Putting things back together I re soldered all of the wires I had
documented with the pic. Then, I noticed there are no connector numbers
stenciled on the PC board!
I looked through the Orion 1 book. No documentation.
Does anyone have a drawing or image of the numbered coax connections to
the circuit board mounted on the back panel plate of the Orion 1?
I appreciate the help on this. Thanks and 73
Paul K.
WA0BAG
--
Paul K. WA0BAG
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|