Good Morning Peg,
Since I think in basic terms, maybe I can try to explain the process.
First thing: Go to http://www.tentec.com/rfsquared/ and down load the
latest Jupiter software update. This takes a very short time. I have a
special directory(folder) for my Ten Tec Updates.
Second: Once downloaded, a double click on the file you downloaded
automatically starts the program, creates a directory(TTFLASH), and places
the appropriate files for upgrading in the directory. I believe it creates
the UPDATE icon(a little wrench) on the desk top.
Third: Make sure you have a serial cable on hand, since this is the link
between the Jupiter and your computer. If you don't, they have them at any
computer store or Radio Shack.
Fourth: Connect the serial cable to the Jupiter and the serial port on your
computer. You will need to know what Com port your computer is using. This
will be needed the first time you use the software.
Fifth: Start the UPDATE software, go setup to set your com port. Then,
click on Process, Update Radio. At this point you have to select the
update version. The Jup updates start with 538v(version number).RUF. For
Rev. 1.19 the file would be 538v1190.RUF. Make sure the Jupiter is ON.
Sixth: Click OK, and your off! The upgrade will take about a half a
minute. After the upgrade is complete, it is best to reset the Jupiter.
This is completed by turning the radio off, pushing and holding any button
on the radio face while you turn the radio ON.
Seventh: Your Ready to Work the World.
If I am wrong, I am sure I will get beaten with jumper cords of 9913 by the
TenTec Police.
Best 73,
Chris KB3A
At 09:24 PM 6/28/2002, haesem@uwplatt.edu wrote:
Hi from a new Jupiter user,
We got a used/demo Jupiter May 16 from Ten-Tec that Stan said would have
the latest firmware. It says 1.09 when powering up. Isn't 1.19 the latest?
Can someone please explain to me in basic terms how to update the latest
firmware from the TT website? The manual does not give much detail and I
have never done this type of operation. Then we can install the internal
tuner.
We are planning to use the Jupiter at a special event station and many of
the club members have never run a TT. Thanks for any help you can give me.
Peg KB9LIE
beautiful downtown Lafayette County, WI
only county in WI without a single stoplight
wonderful location for an antenna farm
those are invitations, Clark!
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|