Kevin,
The way I see it, the whole wafer "torqued over" when
the switch was bound
up. It also looks like the "timing" of the switch can
be adjusted, if
neccessary, by adjusting the shaft position after
everything is re-soldered
and in correct position. You need to make the solder
joint repairs, then
verify the switch contacts are in the correct
positions when it's cycleed
before you can power it up.
good find!
~Lee
____________________________________________________________________________________
The fish are biting.
Get more visitors on your site using Yahoo! Search Marketing.
http://searchmarketing.yahoo.com/arp/sponsoredsearch_v2.php
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|