Thanks to all who offered suggestions on the bad RF preamp. I was able
to trace it to a bad solder joint on the RF Mixer board. Touching up
with the hot soldering iron, and everything is working again... It also
brought up the receive signals without the RF preamp. Some complained
of my transmit signal sometimes being low, but that's probably a mic
problem. Again, thanks for the help from this, the best reflector
around for technical help!
Bill
W4ISH
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|