Bill:
I had the same problem with the 500 Hz filter in my Paragon. Selectivity
was fine but insertion loss was higher than the other filters. I swapped
in the 500 Hz filter from my Corsair and it was fine. I thought of
replacing all of the capacitors in the filter, but figured that the
problem was more likely crystal aging. I didn't want to buy a used
filter, which might have the same aging problem, so I opted for an INRAD
500 Hz filter. The new filter fixed the problem and it seems to have
better skirt selectivity than the old Ten Tec filter.
73,
Bob WB2VUF
On 7/13/2016 12:53 PM, William Hill wrote:
My Omni VI+ loses a very significant amount of signal when either the
500hz or 250 hz on the 6.3 mhz board are selected. Does anyone have a
suggestion what I should try to eliminate this condition?
Bill/W3WH
w3wh@comcast.net
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|