So would one surmise that removing the 2.4 KHz filter, leaving the slot
configured for 2.4 KHz since transmit SSB mode is going to looking for a 2.4
KHz filter, but physically installing a 6.0 KHz filter would make for even
wider response? Hummm, may have to try that.......on the bench of course.
73
Bob, K4TAX
----- Original Message -----
From: "Barry N1EU" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, February 11, 2013 12:18 PM
Subject: Re: [TenTec] eagle
I just took the time to read through the Eagle manual. Much to my
surprise, the spec section seems to indicate that ssb tx bandwidth IS
determined by the roofing filter. So yes, changing the roofing filter
from
2.4Khz to 2.8Khz should have a direct effect on the tx audio.
73,
Barry N1EU
On Sun, Feb 10, 2013 at 9:24 PM, Barry N1EU <barry.n1eu@gmail.com> wrote:
Is that filter is in the tx signal path of the Eagle? The tx signal
isn't
filtered entirely in dsp with configurable bandwidth?
73,
Barry N1EU
On Sun, Feb 10, 2013 at 4:04 PM, Rodney <w3krq@dejazzd.com> wrote:
I got a 2.8 filter from inrad for my Eagle got great audio reports.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|