I'll give it a try someday!
Perhaps I'll learn something new!
It doesn't have either the mass or power to hold temp when touched
to the side of a PL259...but perhaps it has some other voodoo in its'
innards
to get the job done. And I don't even have to buy anything new!! Always
nice!
Tnx!!
....Dave
----- Original Message -----
From: "Jim Brown K9YC" <k9yc@audiosystemsgroup.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, April 05, 2010 8:39 PM
Subject: Re: [TenTec] help in soldering pl259 outside
> On Mon, 5 Apr 2010 20:30:47 -0400, Dave Edwards wrote:
>
>>With a fat clean tinned tip, a silverplated connector, a vise etc...you
>>can
>>probably get the job done....but as the original post mentioned...out in
>>the
>>back yard, with some wind???? No Chance!!
>
> When I first looked at my Hako and those connectors, I thought it would be
> as
> you described, but I was mistaken, and so are you. My bench is outside on
> my
> deck, and ALL of the connectors I've installed were done outside in the
> wind.
> Most of the time, the temperature was in the 50s and 60s.
>
> 73,
>
> Jim K9YC
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|