The tuner can be improved on. I found that under high power on 160 and 80
the SWR would change as the fixed disc ceramic capacitors heated up, which
they do, so I replaced them all with doorknob caps that I found on e-bay and
now it's rock stable at full legal power.
Ron N6IE
www.N6IE.com
----- Original Message -----
From: "Bob McGraw - K4TAX" <RMcGraw@Blomand.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, January 22, 2008 8:31 PM
Subject: Re: [TenTec] Antenna Tuner 238
> In certain cases, for 160M and sometimes 75M, the external cap needs to be
> greater than the 1000 pf item provided. I've found that up to 2700 pf
> might
> be needed in some cases. This tuner will usually match any load Z, any
> phase angle between 10 ohms and 3000 ohms.
>
> FYI - This series of tuners will have some of the lowest loss figures of
> any
> on the market today. Typically less than 1 dB. Plus, being a L network,
> unlike the T networks tuners, there is only one set of adjustment
> parameters
> that produce a proper match.
>
> 73
> Bob, K4TAX
>
>
> ----- Original Message -----
> From: "Jim Brown K9YC" <k9yc@audiosystemsgroup.com>
> To: "Tony Dangelo" <tony@ammocomp.com>; <tentec@contesting.com>
> Sent: Tuesday, January 22, 2008 5:45 PM
> Subject: Re: [TenTec] Antenna Tuner 238
>
>
>> On Tue, 22 Jan 2008 17:26:20 -0500, Tony Dangelo wrote:
>>
>>>Am I missing something?
>>
>> The 229 and 238 (essentially the same tuner in a different color
>> case and with their dial cords wound in the opposite directions) are
>> really excellent tuners, and can be tuned to match almost any
>> reasonable antenna. Sometimes, if the antenna is far from 50 ohms
>> resistive, it can take a while to find the match. And if it's TOO
>> far from 50 ohms, you may not be able to match it. I've had this
>> happen when the antenna is a half wave vertical on 80 or 160, which
>> is a VERY high impedance.
>>
>> TenTec supplies a capacitor that you can connect between two
>> terminals on the back panel to extend the tuning range of the tuner
>> on 80 and 160. That solves the problem I described above.
>>
>> 73,
>>
>> Jim Brown K9YC
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|