TenTec
[Top] [All Lists]

Re: [TenTec] Omni VII spur noise in transit

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Omni VII spur noise in transit
From: MadScientist <dukeshifi@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 9 Apr 2019 09:43:09 -0500
List-post: <mailto:tentec@contesting.com>
Thank you, you confirmed what I had suspected.

I was a bit surprised by the reverse direction of the pot…

Also, I believe the element in my TT 708 mike is bad, so that needs work too.

73,

Gary

> On Apr 9, 2019, at 4:11 AM, Vic Klein via TenTec <tentec@contesting.com> 
> wrote:
> 
> That noise happens with too much audio. If the ALC light is coming on a lot
> or if running mic gain to high or (in my experience) if using the speech
> processor. Back off and it should clean up. Also, the panel control for mic
> gain apparently starts after a mic preamp stage so it may already be too
> high for the particular mic you are using. Adjusting the hardware mic gain
> accessible from under the front panel may be needed. As memory serves, it
> adjusts "backwards" so clockwise is lower.
> 
> 
> 
> =Vic=
> 
> WA4THR
> 
> ----------------------------------------------------------------------------
> --------------------
> 
> 
> To: 
> 
> Discussion of Ten-Tec Equipment <tentec@contesting.com
> <mailto:tentec%40contesting.com> >
> 
> 
> Subject: 
> 
> [TenTec] Omni VII spur noise in transit
> 
> 
> From: 
> 
> MadScientist <dukeshifi@comcast.net <mailto:dukeshifi%40comcast.net> >
> 
> 
> Reply-to: 
> 
> Discussion of Ten-Tec Equipment <tentec@contesting.com
> <mailto:tentec%40contesting.com> >
> 
> 
> Date: 
> 
> Mon, 8 Apr 2019 21:12:26 -0500
> 
> 
> List-post: 
> 
> <mailto:tentec@contesting.com>
> 
> 
> I am not intimately familiar with the Omni VII so its quirks are not on the 
> 
> front page of my RAM.
> 
> 
> 
> I understand them generally well enough to repair them but I have a question
> 
> 
> about the radio in TX.
> 
> 
> 
> Is it common for this model to exhibit slight buckshot sound in the speaker
> on 
> 
> voice peaks? 
> 
> 
> 
> I heard a radio do that long ago and it was considered "normal" for that
> model 
> 
> but one would have thought Ten Tec would have worked t his out by the time
> the 
> 
> Omni VII was designed.
> 
> 
> 
> If this is not normal, then I have more work to do...
> 
> 
> 
> Gary
> 
>                               
> 
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>