Just to add to what Steve has properly suggested, the most practical problem
with the PTO precision is not with the display, rather it is with the slop
within the worm gear, pistol, grease and spring.
Even with the smoothest PTO if you are trying for (example 14.250), there is
some backlash and so you end up wherever the pistol settles with the worm gear.
The most subtle twist of the main tuning knob and that spring is only building
up pressure inside, a little more twist and then it pushes the pistol too far,
past your intended target. Repeat coming back from 14.250.1 ;-)
Ignoring drift, you could never get to 14.250 precisely to start with, and if
you did, you would drift away from it anytime you transmitted, the finals
heating up the PTO coil when you transmit and then it cools when you are off
the key.
The N4YG DDS is not affected by PA heat so your drift is limited to the Corsair
base frequency crystal drift plus some negligable amount from the DDS board
reference.
In practical terms for CW and SSB it's a night and day improvement.
For repeatability, I will tune to (example 14.249.9 just changing to 14.250.0)
with the fine precision of the DDS then a very small rotation in "fine" mode
using the main tuning knob to push the display over to 14.250 solid.
While it is true that repeatability is ultimately determined by the accuracy of
that counter board and some drift in the band crystal, it's still a world
better than before and quite acceptable for CW/SSB net buddies who otherwise
would have howled uncontrollably about having to adjust their RIT control for
you - ONLY you - end EVERY time it is your turn to transmit!!! ;-)
Steve's design improvements have been incorporated into the new N4YG boards
with the added benefit of the removal of a daughterboard circuit.
======
Greg,
The DDS modification still uses the Corsair's "native" frequency readout
circuitry, so setting accuracy is no better or worse than with the PTO.
73,
Steve G3TXQ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|