Thank you Gary. I will try that tonight. I can run 100 watts CW ok.
Best regards - Bry Carling
> On Aug 13, 2014, at 10:36 AM, glhuber <glhuber@msn.com> wrote:
>
> Will the Omni-7 produce 100 Watts when the Tune AND PWR buttons are pressed
> in sequence ? That is the question in my mind, have you left the PWR set at
> 100 Watts so that the USB / digital output is a function of the driving audio
> or is the RF output being limited by the PWR (ALC) level?
>
> 73 & DX,
> Gary AB9M
>
>
>
>
> Sent via the Samsung Galaxy Tab® 3 Lite
>
> -------- Original message --------
> From: Brian Carling <bcarling@cfl.rr.com>
> Date:08/13/2014 9:04 AM (GMT-06:00)
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Subject: Re: [TenTec] Omni VII Digital
>
> Not with digital sigs
>
> Best regards - Bry Carling
>
>
>
>> On Aug 13, 2014, at 9:13 AM, "Gary - AB9M" <glhuber@msn.com> wrote:
>>
>> Can you get the OMNI-VII to produce 100W via the Tune / PWR buttons on the
>> frequency of interest and antenna used?
>>
>>
>> 73 & DX,
>>
>> Gary - AB9M
>>
>> -----Original Message----- From: Louis Ciotti
>> Sent: Wednesday, August 13, 2014 8:00 AM
>> To: bcarling@cfl.rr.com ; Discussion of Ten-Tec Equipment
>> Subject: Re: [TenTec] Omni VII Digital
>>
>> You should be getting way more power out that 20-30 watts. something
>> is just wrong.... you should be able to full power out in the
>> digital modes. Granted some of them there is totally not a need for
>> full output power like PSK-31, JT65, etc. At then end of the day if
>> you are not able to drive the OMNI to 100watts with all the settings
>> maxed out (both on the PC and the rig) something is wrong.
>>
>>> On Wed, Aug 13, 2014 at 7:52 AM, <bcarling@cfl.rr.com> wrote:
>>> It may be "fried" but I seriously doubt it. I was able to work into VK this
>>> morning on 40m
>>> with JT65 and I am now getting 30 - 50 watts output.
>>>
>>> The fault may be in the amount of signal WINDOWS 8 is allowing to come out
>>> of the laptop.
>>>
>>> I am trying to find if there is some level that is pulled down but
>>> everything I see is at 100%
>>>
>>> So far so good. I don't want to get 100 watts out and I think that I
>>> probably don't want any
>>> ALC action while running digital modes. The speech processor actually helps
>>> alittle in my
>>> case.
>>>
>>>> On 12 Aug 2014 at 23:12, Bob McGraw - K4TAX wrote:
>>>>
>>>> The Omni VII does not have low gain. But it seems yours has a defective
>>>> LINE INPUT. I can run mine at 25% and raising the level up on the c
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|