Yes, we are listening and are certainly interested in any aberrant behavior
noted
with one of our rigs. All of this info has been noted by us, and thanks for the
input!
73
Scott Robbins, W4PA at Ten-Tec
> Hmmm, maybe You guys at Ten Tec could change the Scout PTO a little??? I
>KNOW you're listening!!
To: <tentec@contesting.com>
>Date: Mon, 25 Nov 96 00:57:33 EST
>From: montaw@inforamp.net (wayne montague)
>Reply-To: montaw@inforamp.net (wayne montague)
>To: tentec@akorn.net
>Subject: Scout Frequency Drift
>Sender: owner-tentec@akorn.net
>
>A 'Cure' For Scout Drift
>===================
>
>The Scout is a terrific transceiver, but it drifts, despite
>the frequency compensation driven 'CPU' circuitry. It will
>drift upwards over time or upwards faster if the
>transmitter is used and its left on a fixed frequency for
>extended periods. The FLS will attempt to keep the radio
>'LOCKED' until it drifts so much it runs out of
>compensation. You don't notice this unless you leave
>the Scout on a fixed frequency for an hour or more. You can
>tell when its goes into an out of lock state under these
>conditions because the 'unlock' LED will light up. If you
>turn the Scout off and then on again, you'll see that the
>frequency display is higher by about 600 cycles or more.
>
>A call to Ten Tec resulted in the engineer stating that
>this was 'normal'. "Its an inexpensive PTO and not intended
>for this type of operation". "It needs to be tuned
>periodically." I know pretty well what normal should be,
>and this ain't it, especially with a brand new PTO. An
>investigation showed that the PTO always drifted up. Its
>simply over compensated, thats all. There is no excuse for
>a 2-odd MHz oscillator to drift like that. A reason
>perhaps, but calling this 'normal' is obfuscation.
>
>There are 3 capacitors on the PTO circuit board (usually).
>Two of them, or maybe just one will be the equivelent of a
>30 or 33 pF N1500. The other capacitor, "selected in
>production", was an 18 pF NPO in my PTO. The PTO is mostly
>surface mount and God only knows the temperature
>characteristics of those chip capacitors. However, the 3
>(usually) fixed ceramic disks in the PTO are specifically
>for compensation . They usually are - 18 NPO (black bar
>on top) and a 30 pF N1500. The latter may be comprised of 2
>- 15 pF at N1500 marked as 'K3'. Tests showed that what is
>really required is the equivelent of the compensation of a
>30 pf N750. This can be achieved by one of...
>
>- Pulling one 15 pF N1500 and substituting a 15 pF NPO
>- Pulling the 18 and one 15 and substituting a 33 NPO
>- Pulling both 15 pF N1500 and substituting a 30 or 33 pF
> N750
>
>This is not too critical, for we do not need to completely
>stop all drift - we just want to ensure it never drifts out
>of range of the FLS.
>
>When you pull the cover off the PTO, the circuit board will
>come loose. Careful now, because it is now supported only
>by the coil leads. Use at least one cover screw to secure
>the circuit board to the PTO frame. Remove the required
>capacitors with solder wick and re install the
>replacement(s). Be carefull in there!
>
>After this change, I can tune in the local QRU net from a
>cold start and 4 hrs later, turn the Scout off and then on.
>If there is a difference in display reading, it is around
>100 cycles. The same applies to a 1 Hr QSO using the TX.
>Before this change, the display showed a difference of 600
>to 800 cycles, and even worse, the LED 'lock' light would
>come on.
>
>Even if there is an 'FLS' - Frequency Lock System - on the
>Scout, it does little good if the PTO drifts out of lock.
>Now, it locks SOLID and stays there.
>
>Wayne Montague, VE3EFJ montaw@inforamp.net
>
>
73 -- Glenn
----------------------------
Duct Tape is like the Force: It has a light side, and a dark side,
and it holds the Universe together.
AE0Q / V31RY ex: GM5BKC, ZB2WZ, SV0WY, WA0VPK
v31ry@ix.netcom.com -- ARRL LM, QCWA LM, NCVA --
--
FAQ on WWW: http://www.contesting.com/tentecfaq.html
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: w9tw@contesting.com
Sponsored by: Akorn Access, Inc & KM9P
|