Rodney,
With no drive and cherry red, Houston, we have a problem. Short somewhere,
been there done that with the Centurion but mine was drawing about 50 - 75
ma.
Perhaps I a missing part of conversation. Is this 190ma with no drive??
Other friends of mine have been thru this with the 3-500s: no drive but
tube(s) drawing current.
Mike
W8TRN
Mike
W8TRN
----- Original Message -----
From: "Rodney" <w3krq@dejazzd.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Wednesday, August 08, 2018 19:28
Subject: Re: [TenTec] centurion
no it was 190 m with no drive and tubes got red
-----Original Message-----
From: Bob McGraw K4TAX
Sent: Wednesday, August 08, 2018 8:53 PM
To: tentec@contesting.com
Subject: Re: [TenTec] centurion
Is this idle current with no signal? If so it is about correct.
73
Bob, K4TAX
On 8/8/2018 7:42 PM, Rodney wrote:
I was on my Centurion talking and looked at my plate current it was
resting at 190m but the amp was putting out 1200w so tubes I think are
ok.
---
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|