I am assuming that you are going to use the supplied power cable, that has
an extra pair of wires, if you do you could just connect the pair that is
routed to the power switch on the Corsair, in series with the astron power
on/off switch. Leaving the astron power switch in the ON position, you
would then have control of the power to the Corsair with the Corsair
AF/Power control. You may have been considering installating a relay in the
Corsair utilizing the AF/Power control if so my advice is of no use.
Good luck with the project.
Jim, de wd4air
From: Tod Glenn <n7jqw@cordite.com>
Reply-To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
To: Discussion of Ten-Tec Equipment <TenTec@contesting.com>
Subject: [TenTec] Relay for Corsair, argosy
Date: Tue, 16 May 2006 20:30:47 -0600
Greetings all.
I'd like to be able to use the AF power switch on my Corsair and
Argosy with my Astron PS. TenTec states that the AF switch is not
rated to use 12v at the required amperage. They recommend using a
relay, Guardian series 200 or Potter Brumfield PR3DYO. Neither seems
readily available. Can anyone recommend a suitable replacement?
Thanks.
----
Tod Glenn
N7JQW
NAQCC #1283
SKCC #1444
FISTS #12134
ARCI #12420
n7jqw@cordite.com
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|