A 2.4KHz
B 1.8Khz
C 500Hz
D 250Hz
Mode = SSB, A, B, and C are put on 3, 2, 1
Mode = CW B, C, and D are put on 3, 2, 1
If you don't have the 1.8Khz, and don't have the jumper,
that position in the sequence will sound dead. With the
jumper, it will pass signal, but through one of the other
filters (doubles up two of the switch positions: e.g. SSB
3 and 2 are 2.4Khz, 1 is 500Hz). If you have the 1.8, you
should remove the jumper; if you don't, its less annoying
and proper to put it back.
Its in the manual, albeit a bit buried.
And when you turn off the AGC and the s-meter stays on zero,
that's normal, too.
Class dismissed. :-)
Bill W1PA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|