john...
I have one that does the same thing. It's not the radio, it's the 40
meter module
I found out by subbing in a different module 40 meter module and lo
and behold, the problem went away.
I popped the module open and did a quick look, looking for a loose
ground or other problem. never did find one, so when that module is
used and during tx, the display rolls...
doesn't seem to effect the quality of the signal, just makes the
display wobble
Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o
Note: No trees were killed in the sending of this message, but a large
number of electrons were terribly inconvenienced
On Jan 12, 2010, at 9:52 AM, John Peters wrote:
I have a scout that is acting up... with the 3,14 and 28 Mc units
it works just grand.
But with the 7 Mc unit, I reads freq' and copies signals just fine.
When I
go to transmit the freq reads out, goes like it was on a ferris
wheel. it just
don't sit still, until I go back to receive..
Any suggestions ? and which half of the unit is for xmit (the
xtal for both)
Thank you John looking for help
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|