I assume O2 would be the same circuitry, but not sure. The pot that Holger
describes is directly above the AUDIO button on the top of the front panel on
the 565. It's wasn't labelled before, but it is now! And thanks to Holger I now
have a fully functional S-meter calibrated to the correct values defined in the
settings list.
Thank you Holger!
Art Davis
N4UC
> To: tentec@contesting.com
> From: kc9cdt@aol.com
> Date: Fri, 6 Jan 2012 10:27:30 -0500
> Subject: Re: [TenTec] [english 100%] Re: Orion s-meter calibration
>
> What about for Orion II??
> 73,
> Lee
>
>
>
> -----Original Message-----
> From: Holger Göckritz <dj8hb@kcag.de>
> To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
> Sent: Fri, Jan 6, 2012 2:58 am
> Subject: Re: [TenTec] [english 100%] Re: Orion s-meter calibration
>
>
> Hello
> About S-Meter-Calibration for Orion 565.
> Use the Potmeter at the Frontplate up and near the S-Meter, make with a
> small screwdriver the adjustment to get the maximum Number 255 with
> the
> MULTI- Knop for S9 plus 60dB.
> Be carefull about the Settings of S1 Value, S1 is the startingpoint for
> the
> S-meter.
> I thing it is for PREAMP- Button on ,but i have it done with PREAMP off
> and
> for adjusting the S-Meter with a generator use for example S9 the S8
> Value
> and so on one down!
> 73
> DJ8HB
> eof
>
> ----- Original Message -----
> From: "art davis" <n4uc@hotmail.com>
> To: "TenTec reflector" <tentec@contesting.com>
> Sent: Thursday, January 05, 2012 9:00 PM
> Subject: [english 100%] Re: [TenTec] Orion s-meter calibration
>
>
> >
> > I assume that the default settings are defined in the firmware, but
> in my
> > case they do not correspond to the actual meter readings for each
> step. In
> > my case, they are much stingier. When I set each one to correspond to
> the
> > meter, then it way too generous. Also, the maximum count of 255 only
> > drives the meter to S9+30 or so. Same on TX, full power output
> deflects
> > the meter to only about 70, or about the same place as the max
> receive
> > level. Methinks there is something afoul in the meter circuitry.
> > Is there perhaps a hardware adjustment for calibrating the meter
> movement
> > somewhere?
> > Any suggestions?
> > N4UC
> >
> >> Date: Sat, 31 Dec 2011 22:13:32 +0000
> >> From: barry.n1eu@gmail.com
> >> To: tentec@contesting.com
> >> Subject: Re: [TenTec] Orion s-meter calibration
> >>
> >> Tom, it came up a while back on the reflector. My memory ain't what
> >> it used to be, although it probably never was what it used to be ;-)
> >>
> >> 73 & Happy New Year to all,
> >> Barry N1EU
> >>
> >> On Sat, Dec 31, 2011 at 9:54 PM, Tom Berry <tberry1@triad.rr.com>
> wrote:
> >> > Thanks Barry. OK on not recommending that anybody change them.
> >> > I'm curious as to how AL7CR knew that feature was there..
> >> >
> >> > 73 Tom AA4VV
> >> >
> >> >
> >> > On 12/31/2011 4:48 PM, Barry N1EU wrote:
> >> >> I've never seen a description of what those values mean. I just
> >> >> played with them until the Orion s-meter responded similarly to a
> >> >> known good receiver's s-meter. I can't really recommend that
> anybody
> >> >> else changes those values.
> >> >>
> >> >> Barry N1EU
> >> >>
> >> >> On Sat, Dec 31, 2011 at 9:17 PM, Tom Berry<tberry1@triad.rr.com>
> >> >> wrote:
> >> >>> Let me see if I understand this function. I would select an S
> meter
> >> >>> value (say S9) then change the digital count so that the S meter
> >> >>> reads
> >> >>> S9. Is that correct?
> >> >>>
> >> >>> 73 Tom AA4VV
> >> >>>
> >> >>>
> >> >>>
> >> >>> On 12/31/2011 3:48 PM, Barry N1EU wrote:
> >> >>>> Thanks - it's uncharted territory in there but I think I
> managed to
> >> >>>> improve things. I was careful to record the original values
> before
> >> >>>> mucking around.
> >> >>>>
> >> >>>> 73, Barry N1EU
> >> >>>>
> >> >>>> On Sat, Dec 31, 2011 at 7:18 PM, AL7CR<al7cr@punakea.com>
> wrote:
> >> >>>>> Go to the RX menu and press the 15m band select key. This
> will
> >> >>>>> bring up
> >> >>>>> a screen that allows you set the S meter in digital counts.
> >> >>>>>
> >> >>>>> AL7CR
> >> >>>>>
> >> >>>> _______________________________________________
> >> >>>> TenTec mailing list
> >> >>>> TenTec@contesting.com
> >> >>>> http://lists.contesting.com/mailman/listinfo/tentec
> >> >>> _______________________________________________
> >> >>> TenTec mailing list
> >> >>> TenTec@contesting.com
> >> >>> http://lists.contesting.com/mailman/listinfo/tentec
> >> >> _______________________________________________
> >> >> TenTec mailing list
> >> >> TenTec@contesting.com
> >> >> http://lists.contesting.com/mailman/listinfo/tentec
> >> > _______________________________________________
> >> > TenTec mailing list
> >> > TenTec@contesting.com
> >> > http://lists.contesting.com/mailman/listinfo/tentec
> >> _______________________________________________
> >> TenTec mailing list
> >> TenTec@contesting.com
> >> http://lists.contesting.com/mailman/listinfo/tentec
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|