Amen TONY, I hope to have the new beam up for Wed net.
Andy, W3LI
>
> Exactly. Everybody has their own preference for the audio pitch. Some like
> it higher and some lower. Before the days of accurate frequency read-outs
> nobody was too concerned about it. When I am net control I transmit on
> VFO-B and use VFO-A to freely move about on the RX frequency. I find that
> easier than using the RIT. And Net-Control is ALWAYS on frequency hi..hi..
> 73, Tony VE3DWI.
> *************************
>
> ----- Original Message -----
> From: "Mike Bryce" <prosolar@sssnet.com>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Sunday, October 19, 2014 8:45 PM
> Subject: [TenTec] Frequency accuracy
>
>
> Really? I mean really?
>
> Heck, I’ve been told countless times I’m off frequency. My hearing is shot
> so i tend to tune SSB in a bit higher pitch than normal.
>
> “Ah… WB8VGE, you’re 27 hertz too low.
>
> Really?
>
> Yes!
>
> (Me) Does that rig of yours have a RIT?
>
> (Him) I’ll have you know this is the newest generation transceiver on the
> market. It has sixteen VFOs, and eight RITs.
>
> (Me) Then how about turning one on?
>
>
>
> Mike Bryce, WB8VGE
> the heathkit shop
> SunLight energy systems
> J e e p
> o|||||||o
>
>
>
>
>
>
> On Oct 19, 2014, at 6:01 PM, Wade Staggs <tvman1954@gmail.com> wrote:
>
> > Nobody has told me that my personal rig is off frequency
> > in years and I can Earball an FT-101 into correct operation if needed.
> > But,
> > isn't it better to Know for Sure?*
> >
> > * 73 to All from Wade/KJ4WS*
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|