Pete,
Switch to VFO A with the A/B button.
Tune in on the DX station.
Briefly push the LOCK button, the red LED left next to the LOCK button now
lights up.
You now have locked VFO A on the frequency of the DX station.
Push the SPLIT button, the red LED left next the frequency display lights
and you now listen on the VFO A frequency and transmit on the VFO B
frequency.
If you now push and hold the REV A B button, while at the same time you turn
the tuning knob you can listen UP (or maybe DOWN) to try to hear the station
the
DX station is working at the moment. Try to figure out the tuning pattern of
the DX station and place your VFO B frequency on the spot where you think
the DX station will be listening next and make your call at the right time.
Good change you are in the DX stations log soon.
Good luck,
73 Gert, PA3AAV
----- Original Message -----
From: "Pete Bertini" <radioconnection@cox.net>
To: <tentec@contesting.com>
Sent: Wednesday, September 19, 2012 3:45 PM
Subject: [TenTec] Dumb Omni VI question regarding split A/B
Is it possible to LOCK one VFO, and not the other?? I kept screwing up the
DX station's frequency while trying to find the correct QSX. Sorry if I
am
asking the obvious, but I can't figure out how to do it, if it can be
done!
Pete
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|