one of the tubes may be shorted take them out and check the pins for shorts
73 Rod
-----Original Message-----
From: Bry Carling
Sent: Thursday, January 30, 2014 3:30 PM
To: tentec@contesting.com
Subject: [TenTec] 422 Centurion blowing fuses...
I have a Tentec 422 Centurion that is blowing the main 20 Amp fuses...
Looking for insights to this amp failure. It started spontaneously.
I can turn on the main power OK and the filaments light up on the
3-500Zs. The 12 volt power supply is OK because the pilot lights come on.
However when I flip the standby - operate switch to the Operate positionm
the fuse or fuses will blow. I replaced them with good 250V 20A cuses.
I checked the plate transformer windings and everything seems normal for
all three windings. Nothing is shorted. The safety ground for the cover-open
condition is not
across the HV plate supply. I checked that nothing else is shorting out the
plate supply
either.
Does anyone have any idea what might be going on here?
Many thanks - Brian Carling, AF4K
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|