I believe that pot serves to set the offset frequency when the front panel
RIT is switched "off." But hey, ask Steve Hunt.
----- Original Message -----
From: "Barry N1EU" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, November 21, 2011 7:56 AM
Subject: Re: [TenTec] help with Corsair II tx/rx off freq issues
> Dumb question but doesn't that pot simply adjust the center position
> of RIT/XIT so that there's no offset when RIT/XIT is engaged, until
> you turn the knob off-center?
>
> Barry N1EU
>
>
> On Mon, Nov 21, 2011 at 7:43 AM, Mike Hyder -N4NT-
> <Mike_N4NT@charter.net> wrote:
>> I believe, sir, that you are mistaken. I trust my experiences over your
>> opinion. But hey, why not try to discourage the fellow from trying a very
>> simple test?
>>
>> Mike N4NT
>>
>> ----- Original Message -----
>> From: "Steve Hunt" <steve@karinya.net>
>> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
>> Sent: Monday, November 21, 2011 7:34 AM
>> Subject: Re: [TenTec] help with Corsair II tx/rx off freq issues
>>
>>
>>> If the problem is still present when the Offset Tuning is off, it can't
>>> be the balance of those pots. With the OT switched off, the *same* pot
>>> signal is used both for Tx and for Rx.
>>>
>>> 73,
>>> Steve G3TXQ
>>>
>>> On 21/11/2011 04:27, Mike Hyder -N4NT- wrote:
>>>> Scott, I believe there is an internal pot which balances the RIT pot on
>>>> the
>>>> front panel. It sounds like it is not set correctly. Hope that's your
>>>> trouble for it's an easy fix.
>>>>
>>>> 73, Mike N4NT
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|