TenTec
[Top] [All Lists]

Re: [TenTec] OT: Question to the group

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OT: Question to the group
From: Katz Ajamas <ajamas.rn@gmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 14 Jul 2016 02:27:32 +0000
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Dear Rick-

Output power is no good if you can't hear. I mean both ways. RX and TX must
be clean.

More power is not that difficult to come by.

It will be interesting of someone brings a modular system to market.
I think we will see this with digital as the same code can run on a wide
range of hardware to offer
different performance/$. This can be the core of a radio.
This core and firmware can be the IP with all the interfacing open. This
same core can then
be used with appropriate analog hardware for everything from 2200 meter to
sub-mm.

The Ettus research (actually National Instruments now) folks have something
along these lines.
Their radio run GNU radio. Some will also run Labview.
Their USRBP200 or if I'm feeling flush, the 210 will be my next radio.

As an aside. The Eagle is rated:
"AM,FM,AFSK,PSK Duty Cycle:continuous service @100W, 50% duty cycle (Tx/Rx)"
In my book, this is a 50W transmitter.

The 50W Johnson Navigator will hold 50W all day long.
The 100W Drake TR-7 will hold 100W carrier output all day long.


73, -Bob ah7i/w4






> Message: 3
> Date: Wed, 13 Jul 2016 23:43:26 +0200
> From: "rick@dj0ip.de" <Rick@DJ0IP.de>
> To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
> Subject: [TenTec] OT:  Question to the group
> Message-ID: <00d101d1dd4f$972b0970$c5811c50$@de>
> Content-Type: text/plain;       charset="iso-8859-1"
>
> What would you guys think of a new radio that had the following
> characteristics:
>
> ?   SDR radio with knobs, similar size and form factor to the IC-7300
>
> ?  Superior receiver to the IC-7300; roughly on par with the Flex 6300
>
> ?  50w of output power
>
> ?  Cost: $1000
>
>
>
> I guess the big question is, is 50w a show stopper.
>
>
>
> Had someone ask me that question recently (obviously with the intent to
> build this) and I had to pass.
>
> I dunno.
>
> For me I find it OK.
>
> I usually run my Eagle at 60w and when driving my amp, it runs at 60w.
>
>
>
> But my gut tells me most people won?t accept a 50w transmitter.
>
> They are programmed to expect 100w.
>
>
>
> What do you guys think?
>
>
>
> 73
>
> Rick, DJ0IP
>
>
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>