As far as receive, the last low pass filter covers from 22 to 30 MHz, so if
ten meters works that rules out a relay problem. You can verify relay
select voltage for both 10 and 12 meters on the last pin of J14. A bad "or"
steering diode could drop a band, but that is not likely.
As Gary suggested, check the soldering where he advised to do so.
Being able to measure The last miserable project Omni VI I undertook had a
bad solder joint in one of the bandpass filters on the LO Mixer board. Low
LO on RX and TX, low power and very deaf RX. I suspect measuring the LO
level on Jack 26 for each band might give a clue if you have a RF
milli-voltmeter or milli-watt meter.
Pete
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|