Re: [TenTec] S-Meter Calibration in 3.033xa

[Barry N1EU <barry.n1eu@gmail.com>]

On Wed, Apr 10, 2013 at 12:18 PM, John Henry <jhenry@tentec.com> wrote:

> Another change that went in was to address an item that a lot of folks have
> complained about since going from V1 firmware. The S-Meter does not the
> strength of a signal when the RF Gain adjust the signal past the AGC action
> point.
>

It's somewhat ironic - only the Orion 565 ran v1 firmware (Orion II 566
started with v2).  So anyone complaining must have been an Orion 565
owner.  They never got the feature restored but iIt ended up being a new
feature for the Orion II 566.

73, Barry N1EU
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec