I've always just used clip leads.
Barry N1EU
On Sun, Jan 12, 2014 at 8:58 PM, Reed Christiansen <reed@wi9p.com> wrote:
> I am wanting to calibrate the BFO oscillators per page 4-43 of the manual. I
> cannot get my frequency counter probe into the small RG-174 jack at Connector
> 46 of the TX audio board. So, I suppose I need to rig up a test lead that
> will plug in at Connector 46.
>
> Does anyone have a supplier/part number for the male RG-174 plug that
> attaches at Connector 46? Or, even better yet, for about a one foot run of
> coax with that plug on one end and a BNC connector on the other end?
>
> Thanks for any advice you might be able to provide. 73.
>
> --
> Reed L. Christiansen, WI9P
> Email: reed@wi9p.com
> http://www.wi9p.com
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|